© Copyright 2005, Creative Playthings
WILLIAMSBURG WITH WOOD ROOF
19688-300 Rev R (09-20)
Page 16
ASSEMBLY INSTRUCTIONS
D
A
V
Z
STEP 20 — Swing Mount:
Swing Mounts (D) can be attached to any side of a gym. One
swing mount is used for a 7 Ft Swing Beam. No swing mounts
are needed for a 9 Ft Swing Beam.
See the instructions that come with your swing frame for the
steps required to install a swing mount.
STEP21 — Safety Rail:
If you are mounting a swing beam to this gym, install the Safety
Rail (A) to keep children from walking into the swing area. With
no swings, the safety rail is not needed.
Fasten the safety rail to the corner posts on the same side of the
tower as the swings using two 5/16 x 3" lag screws with 5/16" flat
washers as shown. Use the pre-drilled holes provided.
STEP 22 — Front Wall Slats:
Fasten three Wall Slats (V) to the front platform end and the front
wall support, as shown. Use four #10 x 1-5/8" screws in each wall
slat. Leave approximately 2-3/4" between each slat.
Space the bottom of all wall slats approximately 1/2" above the
platform surface.
Hint: Use the Slide Mount (K) to make sure there is enough room
for the slide.
The following steps include instructions for installing wall slats as shown on the cover of this guide. Plan the wall slat
positions according to your layout. In general, try to provide passage wider than 15" for any event. The opening for
a slide should be 24" or wider.
It is extremely important to never leave a gap of
more than 3-1/2" unless that gap is wider than 9".
A gap larger than 3-1/2" might allow a child's body to
slip through leaving the child's head trapped. A head
entrapment can be deadly.
#10 x 1-5/8"
Screws
5/16 x 3"
Lag Screws
1/2" gap
