© Copyright 2018, Creative Playthings
WILLIAMSBURG PREMIUM PACK 12
WILL9WPP12-100 Rev C (05-20)
Page 2
• Skybox Step 17. Wait to install the wall slats on the back
where the bubble panel will mount, and the side where the
Swoosh Slide will mount until after installing the bubble
and slide.
• Skybox Step 21 & 22. Install the slats in reverse orientation
so the opening is on the opposite side. Install the ladder
aligned with the opening.
• Ignore the special instructions regarding mounting with
play floors in the Skybox instructions. A different method
will be used.
• Install the 9ft Swing Beam. Instructions are in carton
63060-222.
• Install the Skybox Play Floor (SC904-800Q) and the
Williamsburg Play Floor (SC908-800Q) using the method
found in the Skybox Play Floor instructions on Page 3 titled
"Install the Skybox Play Floor adjacent to a gym with a Play
Floor." Some parts of the Williamsburg Play Floor will be
cut to fit.
• Install the Skybox Wood Roof (SJ926-810).
• Install the Gable Fans (SM964-402).
• Install the
Bubble Panel
(
AP970-104
) and the wall slats on
either side.
• Install the 14ft Swoosh Slide using the instructions in the
Swoosh Slide pack (50398-700). Install the wall slats on
either side.
• Using a ladder, install the Dormers (SM963-402) in the po-
sitions shown. Ladder access may be obstructed by later
installations.
• Install the Play Walls (SC907-800Q).
• Install the Rock Climbing Wall (AH201-102Q) at the back
of the main tower as shown above.
• Install the Ice Cream Stand (63081-102) at the end of the
Skybox tower as shown above.
• Set the access ladder and slide as shown in the picture on
the preceding page. Check spacing.
• Fasten access brackets to the
inside
of the ladder rails.
Secure the access ladder using the method shown in step
17 of the Williamsburg instructions.
• Fasten the Access Ladder Handles (AG942-400) to the Ac-
cess Ladder.
• Install the slide mount and slide using the method shown in
steps 23 and 24 of the Williamsburg instructions.
• Install wall slats in the postions shown in images above
and on page 1, using the methods from the Williamsburg
Instructions. Gaps must be narrower than 3-1/2" or wider
than 9" to prevent potential head entrapment.
• Mount one hand grip to the entrance wall slat between the
ladder and the slide on the front of the gym. Mount the
other hand grip to the adjacent post at the same height,
using 1/4 x 1-1/2" lag screws and 1/4" flat washers. Drill
3/16" diameter pilot holes for the lag screws.
• Mount one Slide Handle (AG943-400) above the Super
Wave Slide and one above the Swoosh Slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
Rock Climber
Swing Beam
Swoosh Slide
Gable Fan
Bubble Panel
Ice
Cream
Stand
Play Walls
