Assembly
NORTHBRIDGE WITH TENT
19949-100 Rev C (05-18)
© Copyright 2016, Creative Playthings
Page 17
ASSEMBLY INSTRUCTIONS
STEP 24 – Climber Boards:
Take one Rock Board (J) and insert four 1/4" Weld Nuts into
the four 5/16" diameter holes.
Align the top edge of the Rock Board with the top edge of the
Rung Support. Secure the Rock Board to the Rung Support
and back left Leg using four #10 x 2-1/2" T25 Screws.
Use
1/8" diameter pilot holes
to ensure the screws do not split
the Rung Support and Leg.
Align the bottom edge of the Rope Board (K) with the bottom
edge of the Rung Support and Leg. Make sure the Large hole
in the Rope Board is aligned closest to the ground. Secure
the Rope Board to the Rung Support and back left Leg using
four #10 x 2-1/2" T25 Screws.
Use 1/8" diameter pilot holes
to ensure the screws do not split the Rung Support and Leg.
Place the four Spacer Boards (L), Narrow Spacer (U), and
remaining five Rock Boards as shown at right. Secure the
Spacer and Rock Boards spaced evenly between the top
Rock Board and Rope Board using four #10 x 2-1/2" T25
Screws.
Use 1/8" diameter pilot holes
to ensure the screws
do not split the Rung Support and Leg.
The gap between
boards will be approximately 3/8".
STEP 25 – Rocks:
Fasten a Climbing Rock (V) to each pair of holes in the Rock
Boards. Use 1/4 x 1-1/2" Hex Bolts, 1/4" Lock Washers, 8mm
Flat Washers and 1/4" weld nuts. Do not over-tighten the
fasteners. The bolt must seat completely into the Climbing
Rock, and not protrude more than a 1/8" past the end of the
weld nut. Protruding bolts can be a hazard to users, replace
any protruding bolts.
V
K
U
L
J
Typical gap: 3/8"
1/4 x 1-1/2" Hex Bolt
#10 x 2" Screw
STEP 26 – Hand Grips:
Place one Hand Grip (I) flat against the outside face of the left
back Post as shown. The bottom hole of the Hand Grip should
be approximately 1-1/2" above the top of the angled Leg.
With the Hand Grip centered on the face of the Post, mark the
positions of the holes in the Hand Grip. Drill 1/8" diameter pilot
holes 1" deep at the marks. Fasten the Hand Grip using two
1/4" x 1-1/2" Lag Screws and two 8mm Flat Washers.
Place one Hand Grip flat against the outside face of the front
left Leg as shown. The top hole of the Hand Grip should be ap-
proximately 5-1/2" below the top of the angled Leg.
With the Hand Grip centered on the surface of the Leg, mark
the positions of the holes in the Grip. Drill and fasten the Hand
Grip as above.
Repeat with the remaining Grips on the other end of the gym on
the front right Post and back right Leg.
I
1/4 x 1-1/2"
Lag Screw
1-1/2"
5-1/2"
Insert Weld Nuts before
installing top board.
#10 x 2-1/2" T25 Screws
