© Copyright 2018, Creative Playthings
MANCHESTER PREMIUM PACK 9
MANC9WPP9-100 Rev B (05-20)
Page 2
• Spiral mount step 4. Do not install the cross brace.
• Spiral mount step 7. Before installing the side supports,
screw down the narrow deck board omitted in step 22 of
the fun deck assembly. If the deck board blocks a hole
drilled in spiral step 1, insert 5/16" weld nuts first.
• Spiral mount step 9. Stop here before installing the slide
entrance. First install the roof to stabilize the fun deck.
• Install the Fun Deck Wood Roof (63070-404).
• Fun deck wood roof step 8. Wait to install the wall slats
until after the slides and climber are installed.
• When the roof is complete resume installation of the spiral
slide at step 9.
• Install the swing beam using instructions from 63076-303
and step 46 in the Manchester manual. For proper fit within
the play zone found in the Creative Playthings play zone
book, install the swing mount to the corner post near the
rung ladder as shown above.
• Install the remaining Dormer (SM963-402) on the fun deck
roof before installing the swoosh slide and pinnacle climb-
er for better ladder access.
• Assemble the Pinnacle Rock Climber (SH304-101Q) and
lean it into place. Set the Swoosh Slide (15140-400) next
to it. Check the spacing.
• Complete installation of the pinnacle climber.
• Install the swoosh slide.
• Install wall slats on the fun deck in the arrangement shown.
Gaps must be smaller than 3-1/2" or larger than 9" to pre-
vent possible head entrapment.
• Install four wall slats across the opening on the front of the
main tower. All gaps must be smaller than 3-1/2" to prevent
possible head entrapment.
• Install Tic Tac Toe (50514-100), Chalkboard (AS974-500),
and associated wall slats across the back of the main tow-
er in the arrangement shown. Gaps must be smaller than
3-1/2" to prevent potential head entrapment.
• Install the Gable Fans (SM964-402).
• Install the Bubble Panel (AP970-104) at the end of the fun
deck. There are special instructions for installing in this
position on page 3 of the bubble panel assembly guide.
Check the fit before cutting to size.
• Install the Access Handles (AG942-400) on both sides of
the steps.
• Mount the Slide Handle (AG943-400) above the swoosh
slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
