© Copyright 2018, Creative Playthings
MANCHESTER PREMIUM PACK 8
MANC9WPP8-100 Rev B (05-20)
Page 2
• Install the spiral slide mount using the instructions included
in 63056-101.
• Spiral mount step 4. Do not install the cross brace.
• Spiral mount step 7. Before installing the side supports,
screw down the narrow deck board omitted in step 22 of
the fun deck assembly. If the deck board blocks a hole
drilled in spiral step 1, insert 5/16" weld nuts first.
• Spiral mount step 9. Stop here before installing the slide
entrance. First install the roof to stabilize the fun deck.
• Install the Fun Deck Wood Roof (63070-404).
• Fun deck wood roof step 8. Install the fun deck wall slats
as shown. Leave the opening for the spiral slide and leave
off slats at the end of the fun deck for the bubble panel.
Leave a gap for the swoosh slide. The slide mount found
in the swoosh slide pack (50398-700) can be used to de-
termine the space needed.
• When the roof is complete resume installation of the spiral
slide at step 9.
• Install the swing beam using instructions from 63076-303
and step 46 in the Manchester manual. For proper fit within
the play zone found in the Creative Playthings play zone
book, install the swing mount to the corner post near the
rung ladder as shown above.
• Install the remaining Dormer (SM963-402) on the fun deck
roof before installing the swoosh slide for better ladder ac-
cess.
• Install the Swoosh Slide (15140-400) in the position
shown.
• Install four wall slats across the opening on the front of the
main tower. All gaps must be smaller than 3-1/2" to prevent
possible head entrapment.
• Install the Gable Fans (SM964-402).
• Install the Bubble Panel (AP970-104) at the end of the fun
deck. There are special instructions for installing in this
position on page 3 of the bubble panel assembly guide.
Check the fit before cutting to size.
• Install the Access Handles (AG942-400) on both sides of
the steps.
• Mount the Slide Handle (AG943-400) above the swoosh
slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
