© Copyright 2018, Creative Playthings
LEXINGTON PREMIUM PACK 17
LEXI9WPP17-100 Rev C (05-20)
Page 2
• Once the roof, roof supports, ridge cap and swing beam
are installed, proceed with the Skybox tower.
• Skybox step 2. Omit the sandbox end under the gym. The
floor transition from the Skybox Play Floor will be used
instead.
• Skybox step 11. Use the front posts from The Skybox Roof
(SJ926-810) in place of the post extensions.
• Skybox Step 17. Wait to install the wall slats on the back
where the bubble panel will mount, and the side where the
Swoosh Slide will mount until after installing the bubble
and slide.
• Install the Skybox Wood Roof (SJ926-810).
• Install the Skybox Play Floor (SC904-800Q) and the Lex-
ington Play Floor (SC910-800Q) using the method found
in the Skybox Play Floor instructions on Page 3 titled "In-
stall the Skybox Play Floor adjacent to a gym with a Play
Floor." Some parts of the Lex Play Floor will be cut to fit.
• Install the Play Walls (SC909-800Q) on the front, back and
swing end of the main tower.
• Install the Gable Fans (SM964-402).
• Using a ladder, install the Dormers (SM963-402) in the
positions shown on the front page of this guide. Ladder
access will be obstructed by later installations.
• Install the Ice Cream Stand (63081-102).
• Mount the 14ft Swoosh Slide (15140-400) to the front of
the Skybox using the instructions from (50398-700).
• Install the Bubble Panel (AP970-104) above the Ice Cream
Stand.
• Assemble the Rock Climber (AH201-102Q).
• Lean the Access Ladder and Rock Climber as shown
above. Check spacing.
• Secure the access ladder using the method shown in step
17 of the Lexington instructions.
• Complete the Rock Climber installation as instructed in the
rock climber manual.
• Fasten Access Ladder Handles (AG942-400) to the Ac-
cess Ladder.
• Set the Ramp (SH922-800Q) and Super Wave Slide
(15166-400) in place as shown on the front page of this
guide. Check spacing. Make sure the ramp entrance will
clear the ladder up to the skybox.
• Finish securing the ramp.
• Install the slide mount and slide using the method shown
in steps 23 and 24 of the Lexington instructions.
• Install wall slats in the postions shown in images, using
the methods from the Lexington and Skybox instructions.
Gaps must be narrower than 3-1/2" or wider than 9" to
prevent potential head entrapment.
• Mount the hand grips to the entrance wall slats.
• Mount the Slide Handles (AG943-400) above the slides.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
Swing Beam
Bubble Panel
Gable Fan
Rock Climber
Play Walls
Ramp
Ice
Cream
Stand
