LEXINGTON PREMIUM PACK 15
LEXI9WPP15-100 Rev A (04-18)
© Copyright 2018, Creative Playthings
CHILDHOOD STARTS HERE
LEXI9WPP15
Lexington Premium Pack 15
• Start by assembling the Lexington tower. Instructions and hard-
ware are in the cartons noted at left.
The gym is rotated 90° from
the position shown in the instructions.
The components of this gym can be combined with
others to create different play sets. This is the best
order of assembly to create this specific set.
Read this sheet and all instructions included with the
different parts before assembly.
See the Instructions and Owner's Manual included in
carton 63007-445 for important safety information.
Dimensions of assembled package:
24' 0" wide x 13' 7" deep x 11' 6" tall
Cartons for this Play Set:
1 63007-421
Lexington Gym 1 (Hardware)
1 63007-422
Lexington Gym 2
1 63007-423
Lexington Gym 3
1 63007-445
Lexington Roof (Hdwre & Instr)
1 SH946-102 Access Ladder, 5ft
1 AG942-400 Access Ladder Handles (Hdwre & Instr)
1 63058-202
4 Position Swing Beam
1 63060-222
9ft Swing Beam Legs (Hdwre & Instr)
1 50546-777
3 Swings, 1 Trapeze
1 15166-400
10 ft. Super Wave Slide
1 SM964-402 Gable Fans (Hdwre & Instr)
1 SM963-402 Dormer (Hdwre & Instr)
1 63073-101
Clubhouse Window Pk (Hdwre & Instr)
2 40456-402
End Panel
1 40459-402
Double Window Panel
1 40460-402
Door & Window Panel (Hardware)
1 SC910-800Q Lexington Play Floor (Hdwre & Instr)
1 63091-111
Direct Connect Adapter (Hdwre & Instr)
1 8400-202
Spiral Slide, Green (Hardware)
1 AA917-603 Fireman's Pole (Hdwre & Instr)
1 AG943-400 Slide Handle (Hdwre & Instr)
15 1/2"
7 1/4"
3"
0"
• Wait to install the Access Ladder, Slide, and
Wall Slats until after the rest of the play set is
complete.
• Lex step 7. Do not install the safety rail.
• Lex step 8. Do not install the angle braces.
They conflict with the clubhouse panels.
• Lex step 14. Do not install the end wall support
on the spiral slide end of the tower. The direct
connect adapter will take the place.
• Lex step 15. The swing mount isn't needed.
• Lex step 25. Before installing the roof, find the
post where the swing beam will mount. Drill
7/16" diameter holes through the post at 3",
7-1/4" and 15-1/2" below the top of the post as
shown at right.The beam will be mounted to the
front of the post using these holes. Insert one
5/16" weld nut into the top hole on the inside
face of the post. Be sure the threads on the
weld nut are clear, it will be captured by the roof
support. Install the roof.
Dormer
• Mount the Swing Beam using instructions and hardware included
in 63060-222. Mount the beam to the previously drilled holes at
right rather than the way shown in the instructions. You may need
to temporarily disconnect the roof from the post to put the beam in
place.
