© Copyright 2018, Creative Playthings
BRIDGEHAMPTON PREMIUM PACK 3
BRID9WPP3-100 Rev A (12-19)
Page 2
• Skybox step 11. Use the front posts from The Skybox Roof
(SJ926-810) in place of the post extensions.
• Skybox Step 17. Wait to install the wall slats on the back
and side where the bubble panel and slides will mount,
and the side where the Swoosh Slide will mount until after
installing the bubble and slide.
• Skybox Step 21 & 22. Install the slats in reverse orientation
so the opening is on the opposite side. Install the ladder
aligned with the opening.
• Ignore the special instructions regarding mounting with play
floors in the Skybox instructions. Use the method found on
the bottom of page three of the skybox play floor instructions.
• Once the basic Williamsburg-Skybox tower is assembled
assemble the Lexington tower about 92" away from the
Williamsburg.
• Wait to install the Access Ladder, Slide, and Wall Slats until
after the whole play set is complete.
• Lex step 7. Do not install the safety rail. It will be used for
the picnic table.
• Lex step 8. Before securing the angle braces, move the
tower into place 92" from the other tower. Use the bridge
rails from SJ951-102 to assure the alignment is exact.
Continue assembly making sure the posts are plumb and
the towers are level. (Note: the angle braces will be re-
moved to fit the clubhouse panels in a future step.
• Lex step 15. No swing mount is needed.
• After installing the roof, install the bridge between the tow-
ers using the instructions from SJ951-102.
• Install the swing beam. Instructions and hardware are in
the 9' Swing Beam Leg Carton (63060-222).
• Mount the Rock Climbing Wall (AH201-102Q) to the front
center of the Bridge.
• Mount the Bubble Panel (AP970-104) to the back center of
the Bridge.
• Using a ladder, install three Dormers (SM963-402) in the
positions shown on the front page. Ladder access may be
obstructed by later installations.
• Install a Gable Fan (SM964-402) at each end of each roof.
• Install the Wmsburg Play Floor (SC908-800Q) and Sky-
box Play Floor (SC904-800Q) using the method shown on
page 3 of the Skybox Play Floor Manual.
• Install the Lexington Play Floor (SC910-800Q).
• Install the Wmsburg Picnic Table (SD920-800Q).
• Mount the Window and Door Panels (40456-402, 40459-
402, & 40460-402) in the Lexington tower as shown above.
• Mount an Access Ladder (SH946-102), Monkey Bars
(63079-102), and Super Wave Slide (15166-400) to the
front of the Lexington tower.
• Assemble the Spiral Slide (8400-202) and mount it to
the End of the Lexington tower using the Direct Connect
Adapter (63091-111).
• Assemble and mount the Pinnacle Rock Wall (SH304-
101Q) to the front of the Skybox.
• Mount one Access Ladder (SH946-102) and the Ramp
(SH922-800Q) to the front of the Williamsburg tower, ar-
ranged as shown on the front page of this guide.
• Mount two Handles (AG942-400) to each Access Ladder.
• Mount the Ice Cream Stand (63081-102) to the end of the
Skybox.
• Install both Rocket Slides (15140-400) using Skybox Slide
Kits (50398-700).
• Mount a Slide Handle (AG943-400) above the Super Wave
Slide and both Rocket Slides.
• Install the wall slats in the positions shown above and on
the first page, using the methods from the Williamsburg
Instructions. Gaps must be narrower than 3-1/2" or wider
than 9" to prevent potential head entrapment.
• Mount the hand grips to the entrance wall slats.
• Install the Shutters and Flower Box from the Clubhouse Win-
dow Pack (63073-101) to the window panel below the Bridge.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
• Hang the swings.
