Creality Ender-3, Руководство пользователя

Страница: 14 / 24

1. Move the nozzle near the top of the leveling nut. Screw the nut and adjust the distance between the nozzle and the printing platform. The distance is about 0.1mm.
(Thickness of a piece of A4 paper)
2. We can use a piece of A4 paper to assist in leveling, so that the nozzle can just scratch the A4 paper. Adjust the leveling nuts on the four sides in turn until you can feel
the slight resistance from the nozzle when pulling the A4 paper.
3. Test the distance between the nozzle and the print platform is enough or not. Repeat the above steps 1-2 times if necessary.
1.移动喷嘴至调平螺母上方附近。拧动螺母，调节打印平台喷嘴使二者处于好贴合状态，间距约为0.1mm。（一张A4纸的厚度）
2.我们可以利用一张A4纸辅助调平，使喷嘴刚好能在A4纸上产生划痕。依次完成四个边上上调平螺母的调节，不断调整直到在拉动A4纸时能感受到来自喷嘴的轻微阻力。
3.测试平台中间间隙是否合适，如有必要可重复上述步骤1-2次。
8
The even filament adheres right on the
platform.
The nozzle is too close to the platform,
the filaments are not extruded sufficien-
tly, and the nozzle is damaged to result
in plug. It’s easy to scratch the printing
platform.
耗材挤出饱满均匀，刚好贴在平台上。
喷嘴离平台太近，耗材挤出不足，喷嘴出口损伤，
造成堵头,刮伤打印平台。
12