Notes
1.Do not use the Printer in any other way not described herein for avoid personal injury or property damage.
2.Do not place the Printer near flammables, explosives or heat sources. It is best to place it in a well-ventilated, low-dust
environment.
3.Do not expose the Printer to violent vibration or any unstable environment, because this will cause poor print quality.
4.The filaments recommended by the manufacturer are preferred as to avoid clogging in the extrusion head or Printer damage.
5.Do not use any other power cable except the one supplied. Use a grounded three-prong power outlet.
6.Do not contact the skin or eyes directly with photosensitive resin. If skin irritation or discomfort is caused, rinse with water
immediately. If it is serious, consult a doctor immediately.
7. Do not wash the printed product or contact the skin with photosensitive resin. The photosensitive resin is an epoxy resin that is
irritating to the skin. Be sure to wear protective gloves.
8. Do not remove the feed trough at random to prevent the resin on the molding platform from dripping onto the screen;
9. Do not use a sharp sharp tool to scrape off the feed tank release film. If there is any residue left on the feed tank, remove the
molding platform and then remove the feed tank, empty the resin, filter the residue with a filter, clean the feed tank residues. Pay
attention to the protection of the material trough, the trough is a consumable product.
10.Do not use in direct sunlight or in a room with strong light. The machine should be in the air clean environment without obvious
floating objects. Temperature: 30±10 degrees Celsius.
