JR
Expert
Hitec
(right side)
Air/Sanwa
Fut
KO
(left side)
99
Electronics
12
Red Servo Mount
99
4-40 x 1/4”
Flat Head
22
Steering Tie Rod
Plastic Ball Cups
100
Servo Saver Brace
102
1.020”
NOT Included:
Kimbrough Servo Saver:
113 - Airtronics, JR, KO
114 - Futaba
131 - Hitec
101
100
Red Aluminum Servo Mounts
CRC has pre-drilled the Gen-XL for both JR, Expert and Hitec on one side,
and Futaba/KO/Sanwa on the other side. Refer to the diagram below for
instructions on what brand to use and in which locations.
Right side
JR - 3550, 3650, Expert 451, Hitec 225
Left side
Futaba 9650, KO 949, Air/Sanwa 94141,94145
Tie-Rods
Make 2 tie rods as shown above. This 1.02” gap should be a good
starting point for toe-in adjustment. You will need to adjust the final length
after the car is fully ready to run.
Install the servo saver (not included) and assorted hardware in the order
shown above to the right. Put the 4-40 x 3/8” button head screws [27]
through the middle holes of the servo saver as shown and tighten the red
low-profile balls [12] onto them.
102
27
22
4-40 x 3/8”
Button Head
27
Red Low-
Profile Ball
12
12
101
