9
Using the Footswitch:
The special Crate four button footswitch supplied with the VTX350H performs a vari-
ety of functions. The footswitch allows remote channel selection, remote Tap/Save for
each channel, and allows access to an additional DSP preset for each channel of the
amplifier. Use only the supplied Crate four button footswitch with the VTX350H. A stan-
dard 5-wire midi cable (supplied) may be used to connect the footswitch to the amplifier.
3
2
1
4
SWITCH #1:
CH. 1 SELECT;
TAP/SAVE FOR CH. 1
SWITCH #2:
CH. 2 SELECT;
TAP/SAVE FOR CH. 2
SWITCH #3:
CH. 3 SELECT;
TAP/SAVE FOR CH. 3
SWITCH #4:
LED on: DSP BANK A
LED off: DSP BANK B
VTX350H REAR PANEL
FOOTSWITCH
5-Conductor
MIDI cable
VTX350H
Three-Channel Guitar Amplifier with Advanced DSP
NOTE: DSP Bank “B” pre-
sets are only accessible
when the footswitch is
connected to the amplifier.
When the footswitch is not
connected, only DSP Bank
“A” is accessible.
When the footswitch is connected
to the amplifier, the first tap of but-
tons 1 - 3 select the corresponding
channel. Once a channel is selected,
consequent taps of the same buttons
produce the same results as tapping
the front panel Tap/Save button –
you can use the footswitch to store
presets and set the tempo of an
effect. (See page 8.)
The “original” DSP presets are
active for each channel when the #4
footswitch LED is illuminated. These
are referred to as “DSP Bank ‘A’.”
When the #4 button is switched and
the LED is off, a second DSP preset
may be stored and recalled for each
channel - “DSP Bank ‘B’.”
