Crate V18-112 Скачать руководство пользователя страница 9

V18-112/V18-212 Tube Guitar Amplifier with Reverb

9

Important Information About Tubes and Tube Products (continued):

Survival Tips For Tube Amplifiers:

To prolong tube life, observe these tips and recommendations:

•  Match the impedance of your speaker cabinet(s) to your amplifier. Improper impedance 

matching will contribute to early tube degradation and may cause premature tube failure.

•  Make sure the speaker(s) are properly connected prior to turning on the amplifier.

•  After playing the amplifier, allow sufficient time for it to properly cool down prior to moving 

it. A properly cooled amplifier prolongs tube life due to the internal components being less 
susceptible to the damage caused by vibration.

•  Allow the amplifier to warm up to room temperature before turning it on. The heat gener-

ated by the tube elements can crack a cold glass housing.

•  Replace the output tube(s) before the performance degrades or the tubes fail completely. 

Replace the tube(s) on a regular basis (at least once per year or as often as every 4 to 6 
months if you play long and hard every day).

•  Always have the bias checked after replacing the output tubes (unless the amplifier is 

equipped with “selfbiasing circuitry”). This should be done ONLY at a qualified service 
center. Improper biasing could result in the tubes running too hot, which greatly reduces 
the life of the tubes – or too cold, which results in distorted sound regardless of level 
settings. Do not play the amplifier if it exhibits these symptoms – get the bias checked/
adjusted immediately to prevent tube failure and/or other damage.

•  If the locating notch on the base of a power tube breaks off, replace the tube. This signifi-

cantly reduces the risk of damaging your amplifier by incorrectly inserting the tube.

•  Protect the amplifier from dust and moisture. If liquid gets into the amplifier proper, or 

if the amplifier is dropped or otherwise mechanically abused, have it checked out at an 
authorized service center before using it.

•  Proper maintenance and cleaning in combination with routine checkups by your authorized 

service center will insure the best performance and longest life from your amplifier.

CAUTION: Tube replacement should be performed only by qualified service personnel 
who are familiar with the dangers of hazardous voltages that are typically present in 
tube circuitry.

Содержание V18-112













Отзывы: