Crate Palomino V3212, Руководство пользователя

Страница: 4 / 12

V3212 GUITAR AMPLIFIER
4
1. Input: Connect your instrument here by
means of a shielded signal cable.
2. Clean Volume: Use this control to adjust
the output level of the Clean Channel.
3. Clean/Overdrive: This switch, when de-
pressed, selects the Overdrive Channel.
When this switch is in the out position, the
Clean Channel is selected.
4. Overdrive Gain: Use this control to adjust
the gain of the Overdrive Channel. With the
control towards the counter clockwise posi-
tion, the gain is low and very little distortion is
present. As you rotate the control clockwise
the gain increases, producing more overdrive
distortion and a higher output volume level.
5. Treble: Use this control to adjust the out-
put level of the high frequencies. This control
provides 12dB of cut or boost at 6kHz.
6. Boost: This switch, when depressed,
increases the output by 10dB at 900Hz, giv-
ing the middle frequencies more punch.
7. Mid: Use this control to adjust the output
level of the middle frequencies. This control
provides 10dB of cut or boost at 1kHz.
8. Bass: Use this control to adjust the output
level of the low frequencies. This control pro-
vides 8dB of cut or boost at 150Hz.
9. Presence: This switch, when depressed,
increases the output level of the high fre-
quencies by 8dB at 10kHz, giving a more
“glassy” sound to the amplifier. This helps the
output of the amplifier cut through “acousti-
cally dead” rooms.
10. Overdrive Level: Use this control to
adjust the output level of the Overdrive
Channel.
11. Reverb: Use this control to adjust the
amount of reverberation applied to the signal.
With the control fully counter clockwise no
reverb is applied. As you rotate the control
clockwise the amount of reverb increases.
12. Lamp: This lamp illuminates when the
amplifier is turned on.
13. On/Standby: Use this switch to activate
the amplifier. The On/Off switch (#14) should
be turned on first. Allow 20 seconds for the
amplifier to warm up before turning the
Standby switch on.
14. On/Off: Use this switch to turn the ampli-
fier on and off. This switch should be turned
on at least 20 seconds before turning the
Standby switch (#13) on.
1 12 13 14 2 4 5 7 8 10 11 3 6 9
The Front Panel: