15
16
17
18
19
20
21
13 14
21: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the
switch depressed). The switch illuminates when the power is on.
GT65/212
Guitar Amplifier
100VAC: T2.5A 250V
120VAC: T2A 250V
230/240VAC: T1.25A 250V
CAUTION:
TO REDUCE THE RISK O F F I R E ,
R E P L AC E F U S E W I T H SAME TYPE AND RATING.
ATTENTION:
UTILISER UN FUSI B L E D E
R E C H A N G E D E M E M E TYPE.
CLEAN/
SOLO/
RHYTHM
REVERB
FOOTSWITCH
EXTENSION
SPEAKER
INSERT
22
23
24
25
26
The Rear Panel:
22: FUSE: The fuse protects the amplifier from damages caused by a faulty AC power source and/or
other problems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to
fail, check the AC source – if the source is okay, contact your Crate dealer for service information.
23: EXTENSION SPEAKER: Use this jack to connect the amplifier to an external speaker cabinet.
This jack is wired in series with the internal speaker(s) which remain active when an extension
speaker is connected.
24: REVERB FOOTSWITCH: Use this jack to connect the 1/4” mono plug on the footswitch cable to
the three-button footswitch (supplied). This allows you to remotely turn the reverb on and off.
25: CLEAN/SOLO/RHYTHM FOOTSWITCH: Use this jack to connect the 1/4” stereo plug on the
footswitch cable to the three-button footswitch (supplied). This allows you to remotely switch between
the Clean and Distortion channels and between the Solo and Rhythm channels.
26: INSERT: Use this jack to connect an external
effects device to the amplifier. Use Crate’s
STP201, STP202, or STP203 stereo-to-mono Y-
cord or an adapter such as Crate’s YPP117 and
two 1/4” mono signal cables to connect to the
effect as shown to the immediate right.
27: AC LINE CORD (not shown): This grounded
power cord is to be plugged into a grounded power
outlet, wired to current electrical codes and compati-
ble with the voltage, power, and frequency require-
ments stated on the rear panel. Do not attempt to
defeat the safety ground connection.
TIP
RING
SLEEVE
RETURN
SEND
GROUND
Stereo-to-mono Y-cord:
to Insert
jack
to Insert
jack
(STP201, 3'
STP202, 6'
STP203, 9')
(YPP117)
(1/4"-TO-1/4"
MONO CABLES)
to
effect
"OUT"
jack
to
effect
"IN"
jack
TIP
RING
SLEEVE
Y-adapter and 2 cables:
RING
RING
TIP
TIP
to
effect
"OUT"
jack
to
effect
"IN"
jack
External Effect
External Effect
5
