Features:
The Input Channels:
• Peak LEDs for optimum level settings
• Three bands of equalization
• Monitor, effects, and pan controls
• Output level controls
• Pad switch (mono channels) to accommodate “hot” signals
• XLR balanced low impedance mic input jacks
• 1/4” balanced high-Z line input jacks
The Master Section:
• Tri-Power! Three internal power amplifiers (PM82T only) - one for the monitor, two for the
main speaker outputs
• Two internal power amplifiers (PM62S, PM82S) for the main speaker outputs
• Built in Limiter to prevent overdriving the amplifiers
• Two 7-band graphic EQs - one for monitor, one for mains
• Five-step LED displays with Limiter indicators for monitoring the output signals
• Effects send and return controls
• Switchable phantom power (+48V)
• 16-Program Digital Signal Processor (DSP) with on/off switch
• Footswitch jack for remote control of DSP on/off
• Headphones jack with level control
• DSP line out/aux in jacks for external effects
• Tape in and tape out jacks for recording and play back
• Main and monitor line out jacks
3
PM62S/PM82S/PM82T Powered Mixers
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequen-
cy energy and, if not installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this device not expressly approved by SLM Electronics could void the user’s
authority to operate the equipment under FCC rules.
