Crane EE-7588, Инструкция по эксплуатации

Страница: 7 / 11

5
TECHNICAL SPECIFICATIONS
Maximum Power 1500W
Heat Power Settings 750W + 750W
Voltage 120 VAC / 60Hz
ASSEMBLY & USER INFORMATION:
CAUTION:
Do not use this heater if it has not been fully assembled. Make sure the base screws
holding the base & main unit together are securely tightened. Keep plastic
wrapping away from children.
ASSEMBLY:
1. Remove tie from power cord & unravel
2. Connect the front base to the back base by placing attached pegs into
corresponding holes.
3. Slip the power cord through the assembled base from the top.
4. Position the connected base piece so the front base piece is facing the same
direction as the front heat grill.
5. Adjust base so the screw holes align properly. Use the 4 base screws
provided (taped to the tower heater) to secure the base to the main unit.
6. Once base is secured, unscrew on side of the cord holder (on the bottom of
the base), place the power cord in the slot, then swing the cord holder back
over the cord & replace the screw.
7. The power cord should now fit into the groove on the back of the base piece
so the heater sits level on the floor.