Crane EE-6490, Инструкция по эксплуатации, Страница: 7 / 12

6
OPERATION
During the first few minutes of initial use, you may notice a slight odor; this is normal and
will quickly disappear.
CAUTION: DO NOT touch grill cover while hot!
1. Place the product on a flat, steady, stable, heat-resistant surface.
2. Plug the Power Cord into a standard 120 VAC electrical outlet.
3. Turn the Heat Select Knob to either low heat or high heat position.
4. Allow the heater to warm up until the room temperature reaches your desired
comfort level.
5. The Power Light shows that the heater is plugged into a power source.
SAFETY PROTECTION SYSTEMS
This unit has protection safeguards that shut off the unit when components become
excessively hot or if it tips over.
IF OVERHEATED
If heater becomes overheated, it will shut down automatically and the heater will
turn off. Please Note that red indicator light will go off and you may smell a
slight odor due to the coils overheating. This is normal and the odor will subside.
Remove any nearby objects that may be causing overheat conditions. Keep at
least three feet of space on all sides of the unit to allow adequate air circulation.
Use the unit in a well-ventilated area.
Place the unit on a flat, smooth, stable surface.
The unit will restart automatically when it has cooled sufficiently. Please Note
this cool-down period could take 30-45 minutes. When heater is cooled the red
Power Light will come back on and the heater will begin to heat.
MAINTENANCE
CAUTION:
Always be sure that the appliance is switched OFF and unplugged before
cleaning or attempting to store the item. Do not immerse heater in water or
allow water to drip into the interior of the heater, as this could create an
electric shock hazard.
CARE AND CLEANING
CAUTION: Allow the product to completely cool before handling, cleaning or storing.
Ensure the Heat Select Knob is in the OFF position and the Power cord is unplugged
from the electrical outlet before cleaning the product.
Do not touch hot surfaces.
Clean the exterior surface of the product by wiping it with a soft, damp cloth.
Do not use any abrasive cleaners or solvents, as product damage will occur.