C.A.S.T. CABLE REQUIREMENTS
C.A.S.T. is a system that we use to transport balanced, analogue audio using standard
network cabling. Using a shielded Cat 5e, Cat 6, or Cat 7 cable instead of 4 XLRs allows
you to not only reduce cable spaghetti in your studio but also distribute audio around
studios or stages using affordable, readily available cabling whilst achieving the
highest-quality sonic results.
Each C.A.S.T. connection on a Cranborne Audio product features unique optimisation
to ensure that the maximum signal integrity is transmitted over shielded Cat 5e, Cat 6,
and Cat 7 cables for distances of up to 100m(330ft) without high-end roll-off and with
very low-crosstalk.
Recommendation
- For best possible performance over maximum distances, we
recommend using
Cat 7
cables with robust connectors to ensure that the C.A.S.T.
connection is secure and will remain impervious to RF and crosstalk.
Minimum Requirement
- As a minimum requirement, you can consider using
Shielded Cat 5e or Cat 6 cabling provided that the cables and connectors themselves
are fully shielded and are not used for distances greater than 20m.
Note:
Many Cat cables are marketed ‘shielded’ but feature plastic connectors on either
end. Cables with incorrect shielding will not perform as expected and 48V Phantom
Power will not pass through correctly. Any damage caused to the unit as a result of
unsupported cabling is not covered under the Cranborne Audio warranty.
Page 3
©2022 Cranborne Audio Ltd
