Cramer 2911586, Руководство пользователя, Страница: 7 / 145

• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
6 TRANSPORTATION AND
STORAGE
WARNING
Remove the battery pack from the machine before
transportation and storage.
6.1 STORE THE MACHINE
• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7 TROUBLESHOOTING
Problem Possible Cause Solution
The ma-
chine stops
when you
cut. The guard is not
attached to the ma-
chine. Remove the battery pack
and attach the guard to
the machine.
Cutting blade is
damaged. Replace the blade (al-
ways wear protective
gloves).
The grass winds
around the motor
shaft or the trim-
mer head. 1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
The motor is over-
loaded. 1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
8" in pass.
Problem Possible Cause Solution
Nut cannot
be removed
to release
cutting
blade. Damaged thread
on nut/ shaft. 1. Cut with the tip of the
line, avoid stones, walls
and other hard objects.
2. Advance the cutting
line regularly to keep full
cutting width.
Cutting
blade fails
to rotate. Cutting blade ob-
structed Check underneath the
machine and clear out as
necessary (always wear
protective gloves).
Blade nut loose Tighten nut ensuring the
blade, rider plate and
dome washer are all
present and central (al-
ways wear protective
gloves).
Grass too high/
dense Grass too high: Cut in
stages
Grass too dense: Reduce
rate of cutting every time.
The grass
winds
around the
trimmer
head and
motor hous-
ing. Cut tall grass at
ground level. 1. Cut tall grass from the
top down.
2. Remove no more than
8" in each pass to prevent
wrapping.
Vibration
increases
obviously. Cutting blade
damaged. Replace the blade (al-
ways wear protective
gloves)
Debris build up on
cutting head Clean cutting head and
remove debris
Blade nut loose Tighten nut bolt to ensure
the blade, outer cup and
plate are all present and
central (always wear pro-
tective gloves).
Cutting blade in-
correctly fitted Remove cutting blade
and refit in a fully central
position. Use guide rings
on the blade to ensure
correct central alignment.
Poor cut-
ting per-
formance Cutting guard en-
crusted with debris Clean inside of cutting
guard
Cutting blade
blunt Flip/replace blade
6
English
EN