1 x Remote Control ( uses 1 x CR 2025 button cell,induded )
A )
2
,
V
2
1
C
D
t
u
p
t
u
O
1 x Audio Connection Cable with 3.5mm Stereo plugs
1 x User's Manual
2 x Wooden Stand
6 x Assembly Screws
1 x Screwdriver
1 x AC/DC Adaptor ( Input: AC 100-240V~,50/60Hz 1A;
Accessories:
FM 87.5-108 MHz
DC 12V,2A
4 x 4 Ohms, 6 W
DC 3V,1 x CR 2025 button cell (Included)
10
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
