Craftsman Professional 235.19906, Руководство пользователя

Страница: 4 / 20

4
WARNING
is used to indicate the presence of a hazard which
can cause severe personal injury or death if the warning is ignored.
CAUTION
is used to indicate the presence of a hazard which will
or can cause minor personal injury or property damage if the cau-
tion is ignored.
NOTICE
is used to notify people of installation, operation or main-
tenance information which is important but not hazard related.
This Craftsman Sander is de-
signed to prepare metal and wood
surfaces for painting and finishing
operations.
WARNING:
Important safety information en-
closed.
Read this manual before operating
tool.
It is the responsibility of an em-
ployer to place the information in
this manual into the hands of any-
one who operates this device.
Failure to observe the following
warnings could result in injury.
SANDER SPECIFIC
WARNINGS
•
These Sanders will operate at
the free speed specified on the
label if the air supply line fur-
nishes 90 psig (6.2 bar/620
kPa) air pressure at the tool.
Operation at higher air pressure
will result in excessive speed.
•
Use only a sanding pad, buffing
wheel or polishing bonnet with
these tools. Do not use any
grinding wheel, bur or metal
removing accessory with these
tools. Never use an accessory
having a maximum operating
speed less than the free speed
of the Sander in which it is
being used.
•
When using a pad having a
shank, insert the shank to full
depth in the collet. When using
a pad on a threaded arbor,
make certain the flange nut is
tightened securely. Check the
tightness of the collet nut or
flange nut before operating a
Sander to make certain it will
not loosen during operation.
NOTICE:
The use of other than
genuine Craftsman replacement
parts may result in safety hazards,
decreased tool performance, in-
creased maintenance, and may
invalidate all warranties.
Repairs should be made only by
authorized trained personnel.
PLACING TOOL IN SERVICE
•
Always operate, inspect and
maintain this tool in accordance
with all regulations (local, state,
federal and country), that may
apply to hand–held/hand–oper-
ated pneumatic tools.
•
For safety, top performance,
and maximum durability of
parts, operate this tool at
90 psig (6.2 bar/620 kPa) maxi-
mum air pressure at the inlet
with 5/16” (8 mm) inside diame-
ter air supply hose.
•
Always turn off the air supply
and disconnect the air supply
hose before installing, removing
or adjusting any accessory on
this tool, or before performing
any maintenance on this tool.