3
English
short pants, sandals or go barefoot. Secure hair above
shoulder level.
b )
Adjust the handle to provide the best grip, if
applicable.
c )
Make sure the attachment is not in contact with
anything before starting the unit.
d )
Use the unit only in daylight or good artificial
light.
e )
Avoid accidental starting.
Be in the starting
position whenever pulling the starter rope. The
operator and unit must be in a stable position while
starting. Refer to Starting and Stopping.
f )
Use the right tool.
Only use this tool for its intended
purpose.
g )
Always hold the unit with both hands when
operating.
Keep a firm grip on both handles or grips.
h )
Do not overreach.
Always keep proper footing and
balance. Take extra care when working on stairs,
steep slopes or inclines. To avoid serious injury, do not
operate the unit while on a ladder or a roof.
i )
Keep hands, face, and feet away from all moving
parts
. Do not touch or try to stop moving parts.
j )
Do not touch the engine, gear housing or
muffler.
These parts get extremely hot from
operation, even after the unit is turned off.
k )
Do not operate the unit faster than the speed
needed to do the job.
Do not run the unit at high
speed when not in use.
l )
Do not force the unit.
It will do a better, safer job
when used at the intended rate.
m )
Always stop the unit when operation is delayed
or when walking from one location to another.
n )
If you strike or become entangled with a foreign
object, stop the unit immediately and check for
damage.
Do not operate the unit before repairing
damage. Do not operate the unit with loose or
damaged parts.
o )
Turn the engine to off and disconnect the spark
plug for maintenance or repair.
p )
Use only original equipment manufacturer
(OEM) replacement parts and accessories for this
unit.
Use of any other parts or accessories could lead
to serious injury to the user, or damage to the unit,
and void the warranty.
q )
Keep the unit clean.
Carefully remove vegetation
and other debris that could block moving parts.
r )
To reduce fire hazard, replace a faulty muffler
and spark arrestor.
Keep the engine and muffler free
from grass, leaves, excessive grease or carbon build up.
s )
If the unit starts to vibrate abnormally, stop the
unit immediately.
Inspect the unit for the cause of
the vibration. Vibration is generally an indicator of
trouble.
Other Safety Warnings
WARNING:
All service other than the
maintenance procedures described in this
manual should be performed by a qualified
service dealer.
a )
Before inspecting, servicing, cleaning, storing,
transporting or replacing any parts on the unit:
1. Stop the unit.
2. Make sure all moving parts have stopped.
3. Allow the unit to cool.
4. Disconnect the spark plug wire.
b )
Secure the unit while transporting.
c )
Never store the unit with fuel in the tank, inside a
building where fumes may reach an open flame
(pilot lights, etc.) or sparks (switches, electrical
motors, etc.).
d )
Store the unit in a dry place, secured or at a
height to prevent unauthorized use or damage.
Keep the unit out of the reach of children.
e )
Never douse or squirt the unit with water or any
other liquid.
Keep handles dry and clean (free from
debris, oil and grease). Clean the unit after each use.
Refer to Cleaning and Storage. Do not use solvents or
strong detergents.
f )
Keep these instructions.
Refer to them often and
use them to instruct other users. If you loan this unit to
others, also loan them these instructions.
Service
WARNING: Repairs should only be performed by
qualified service personnel using only identical
replacement parts.
This will ensure that the safety
of the power tool is maintained."
Intended Use
a )
Cutting and trimming of hedges, bushes and
ornamental shrubs in the domestic sector only.
All other uses are expressly excluded.
b )
NOT for professional use.
