English
8
Proper Hand Position (Fig. D)
WARNING:
To reduce the risk of serious personal
injury,
ALWAYS
use proper hand position as shown.
WARNING:
To reduce the risk of serious personal
injury,
ALWAYS
hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle
6
.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and lock off the tool before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
can cause injury.
Fig. D
6
Cleaning
WARNING:
Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and lock off thetool before
making any adjustments or removing/installing
attachments or accessories.
An accidental start-up
can cause injury.
Inserting and Removing Bits (Fig. C)
CAUTION:
To avoid screwdriver being turned on
accidentally, do not carry in your pocket.
To install an accessory,
fully insert the accessory into the
cavity in the hex spindle as shown in Figure C. The accessory
snaps into place.
To remove an accessory
, pull it straight out.
nOTE:
The spindle accepts 1/4" (6.4 mm) hex
accessories only.
Transport Lock (Fig. A)
CAUTION:
To avoid accidental actuation during
transport or storage always lock the tool.
To unlock the tool,
slide the transport lock
2
toward
the shaft.
To lock the tool,
slide the transport lock toward the base.
NOTICE:
Do not use the screwdriver as a pry bar.
Fig.C
Accessories
WARNING:
Since accessories, other than those
offered by CRAFTSMAN,
have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
LED Light (Fig. A)
CAUTION: When using the worklight for purposes
other than screwdriving or drilling be sure to
Performing an Application (Fig. A, D)
Screwdriving
Your screwdriver uses gyroscopic technology to sense your
hand motion. To operate:
1. Grasp the screwdriver as shown in Figure D and ensure
that the transport lock
2
is in the unlocked position.
2. Press and hold in the motion control activation
trigger
1
.
3. When the LED worklight
3
illuminates the tool is ready
for use.
a.
To tighten,
rotate your hand clockwise.
b.
To loosen,
rotate your hand counterclockwise.
4. To turn the tool off, release the motion control
activation trigger.
Variable Speed
The spindle speed is dependent upon the amount
of rotation.
•
small rotations
operate the tool at a slower speed.
•
large rotations
operate the tool at a higher speed.
NOTE:
For best performance, screw into pre-drilled holes.
remove all accessories. Unused accessories could
cause injury or property damage.
When the screwdriver is activated by pulling the motion
control activation trigger
1
, the LED worklight
3
will
automatically come on. The LED worklight will go off
twenty seconds after the motion control activation trigger
is released.
