Craftsman 944.362151, Руководство пользователя

Страница: 15 / 24

15
Loss of power 1. Rear of housing or blade 1. Set to “Higher Cut” position.
dragging in heavy grass.
2. Cutting too much grass. 2. Set to “Higher Cut”
position.
3. Dirty air fi lter. 3. Clean/replace air fi lter.
4. Buildup of grass, leaves, 4. Clean underside of mower
and trash under mower. housing.
5. Too much oil in engine. 5. Check oil level.
6. Walking speed too fast. 6. Cut at slower walking
speed.
Poor cut – 1. Worn, bent or loose blade. 1. Replace blade. Tighten
uneven blade bolt.
2. Wheel heights uneven. 2. Set all wheels at same
height.
3. Buildup of grass, leaves 3. Clean underside of
and trash under mower. mower housing.
Excessive 1. Worn, bent or loose blade. 1. Replace blade. Tighten
vibration blade bolt.
2. Bent engine crankshaft. 2. Contact a Sears or other
qualifi ed service center.
Starter rope 1. Engine fl ywheel brake is 1. Depress control bar to
hard to pull on when control bar is upper handle before
released. pulling starter rope.
2. Bent engine crankshaft. 2. Contact a Sears or other
qualifi ed service center.
3. Blade adapter broken. 3. Replace blade adapter.
4. Blade dragging in grass. 4. Move lawn mower to cut
grass or to hard surface.
Grass catcher 1. Cut ting height too low. 1. Raise cutting height.
not fi lling (if so 2. Lift on blade worn off. 2. Replace blade.
equipped) 3. Catcher not venting air. 3. Clean grass catcher.
Hard to push 1. Grass is too high or wheel 1. Raise cutting height.
height is too low.
2. Rear of housing or blade 2. Raise rear of mower housing
dragging in heavy grass. one (1) setting higher.
3. Grass catcher too full. 3. Empty grass catcher.
4. Handle height position not 4. Adjust handle height to
right for you. suit.
PROBLEM CAUSE CORRECTION
TROUBLESHOOTING - See appropriate section in manual unless directed
to a Sears Service Center.