M8 x 2
5
Hex Bolt
16
)
M6 x 12 Hex Bolt
)
10 mm Wrench
14 mm Wrench
NOTE Not all assembly instructions will relate to your model.
SIDE HANDLE ATTACHMENT
M6 x 12 Hex Bolt
HARDWARE
2
Washers
16
)
4
from the date of sale this product is
warranted against defects in material or workmanship.
To obtain warranty coverage return a defective part to the retailer
from which the product was first purchased.
Transform SR Brands Management LLC, Hoffman Estates, IL 60179.
Locking Swivel Caster
2 X
Washer
16 X
M8 x 25 Hex Bolt
16 X
Rigid Caster
2 X
Cabinet handle
M6 x 12 Hex Bolt
4 X
1 X
10 mm Wrench
Use a 10 mm wrench and 2 M6 x 12 Hex Bolts to tighten
the handle into the attachment holes on the cabinet as
shown. Tighten securely only by hand. Do not overtighten.
Use a 14 mm wrench and 4 M8 x 25 Hex Bolts and
Washers to attach each caster to a bottom corner of
the cabinet as shown. Install the locking swivel casters
on the handle side of the cabinet. Install the fixed
casters on side of the cabinet opposite the handle.
Securely tighten all bolts. Return the cart to its upright
position. Place the work top on the top of cabinet.
CASTER INSTALLATION
REMOVING DRAWERS
OPERATION
PUSH DOWN
OTHER RELEASE LEVER
PUSH UP
ONE RELEASE LEVER
Pull drawer out so that it is almost fully extended.
Push
up
on one release lever while pulling down on the
other
o
ne
. Pull the drawer outward until it releases from
the drawer slide
s
.
RAISE AND RELEASE DRAWER HANDLES
These units are equipped with safety drawer
latches. To open, lift up the drawer handle while pulling
towards you. To close, shut the drawer firmly until
drawer
the latch engages. If the drawer does not stay closed, the
latch hook may be bent,
or it may be rubbing against
the drawer slides.
To fix this problem, slightly bend the
hook until it engages the latch.
Latch Hook
Take out casters from the left bottom drawer.
Extend the Slide
Bracket
INSTALLING DRAWERS
Slide
Extend the drawer slides from the tool chest/cabinet.
Insert the brackets on each side of the drawer into
the slots in the chest/cabinet slides, being careful that
they are properly positioned. Once properly inserted,
completely close the drawer to set the slides in their
proper positions.
c
M8 x 25 Hex Bolt (Qty:16)
Remove the work top from the cabinet top before
laying the cabinet down.
