10
1
3
6
INSTALL CARTRIDGE
OPERATING INSTRUCTIONS
!
Notice
Do not damage seals of
equipment being lubricated by excessive
pressure or lubricant volume.
!
Notice
If grease does not come out of
coupler (
1
) after ten strokes of lever
handle (
3
), refer to
Expel.Air.Pockets
section on
page.5.
Do not over pressurize grease gun.
Extreme pressure may cause nozzle
extension to burst.
Use only identical part nozzle exten-
sion replacement. See
Service.Parts
list
on
page.6
.
Keep hands clear of the extension
during operation of the grease gun.
Grease gun can develop high pressure
up to 10,000 psi (
689 bar
). Use safety
glasses and gloves for protection during
operation.
Failure to comply with this warning
may result in death or serious injury.
WA R N I N G
1.
While holding grease gun container
tube (
6
), loosen grease gun head (
10
)
two turns.
1.
Wipe fittings clean before lubricating.
2.
Push coupler (
1
) onto fitting at slight
angle and then center coupler (
1
) on
the fitting
3.
Operate lever handle (
3
) to lubricate.
4.
After lubricating turn coupler (
1
) at a
slight angle to release grip of the
coupler jaws from the fitting.
!
Notice
.
Failure to clean and inspect grease gun
will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
2.
Pull T-handle (
8
) to extend follower rod
(
5
) fully and slide into slot.
3.
Unscrew container tube (
6
) from
grease gun head (
10
).
4.
Remove empty grease cartridge (if
present) from container tube (
6
).
5.
Remove large cap from top end of new
grease cartridge.
6.
Insert new grease cartridge top end
first into container tube (
6
).
7.
Remove pull tab from bottom end of
new grease cartridge.
8.
Screw container tube (
6
) back onto
grease gun head (
10
) and tighten.
9.
Pull lever handle (
3
) away from
container tube (
6
).
10.
Pull back and remove follower rod (
5
)
from slot.
Pull tab
Grease cartridge
Large cap
6
8
5
11.
Turn T-handle (
8
) 90° and push into
container tube (
6
)
12.
Loosen grease gun head (
10
) two turns
to expel air and retighten.
3
