16
®
TABLE SAW 315.228110
Assembly is best done in the area where the saw will be used. When you remove the table saw base, loose
parts, and hardware from the packing materials, check all items with the loose parts list and drawing. If you are
unsure about the description of any part, refer to the drawing. If any parts are missing, delay assembling until
you have obtained the missing part(s).
A. ASSEMBLY OF LEG STAND, STORAGE
BRACKETS, AND MOUNTING TO SAW
ASSEMBLING LEG STAND
See Figures 8 and 9.
■
Take the following hardware from the leg stand
hardware bag:
24 carriage bolts (5/16-18 x 3/4 in.)
4 leveling feet
32 flat washers (5/16 in.)
32 hex nuts (5/16-18)
Note: Remaining hardware from this bag is used for
mounting leg stand on the table saw base and
mounting storage brackets to upper brace.
■
Take 4 legs and 8 braces from loose parts.
■
Place an upper side brace inside two of the legs,
Figure 8
ASSEMBLY
LEVELING FOOT
CARRIAGE
BOLT
WASHER
BOLT
HEX NUT
UPPER BRACE
LOWER BRACE
STORAGE
BRACKET(S)
HEX NUT
LEG
SCREW
WASHER
HEX
NUT
WASHER
HEX NUT
WASHER
HEX NUT
with the legs wide end up. (Upper side braces have
two large holes in each end.) Make sure the two
posts on the leg align with the small holes on the
brace.
■
Align the two large holes on the brace and the
legs. Insert the carriage bolts. Add flat washers
and hex nuts and hand tighten. Repeat for the
other upper brace. These are the front and back
sets.
■
For the side sets, install a upper brace on two legs.
Add hardware and finger tighten. Repeat for the
other upper brace.
■
Use the same steps to install the lower braces.
Tighten all hex nuts with a wrench.
■
Place a hex nut and flat washer on each leveling
foot. Install the leveling feet from the bottom of
UPPER
SIDE BRACE
Содержание 315.228110
Страница 43: ...43 TABLE SAW 315 228110 NOTES ...