11
7.
Open Hood by pushing in on the rear, right-side tab with your right hand, as
shown in 1 of Figure 13, and lifting the cover with your left hand in the center
rear of the bagger cover, 2.
1
2
Figure 13
8.
Install the bag assemblies onto the bag support brackets by inserting the
front edge in first, as shown in Figure 14, and setting the back edge down
until it fits into the assembly.
1
2
Figure 14
ASSEMBLY AND INSTALLATION
6.
Slide the hinge pin into the hole located on the mounting tab, as in Figure
11. Use the cut-out window (See inset in Figure 11) to line up the hinge pin
on the other side and push pin all the way in until it reaches the end-stop. At
this point the pin clips into place and is secured by a tab in the bagger cover.
See Figure 12.
Figure 11
Figure 12
