9 ― English
ASSEMBLY
UNPACKING
This product requires assembly.
■ Carefully remove the product and any
accessories from the box. Make sure that all
items listed in the packing list are included.
PACKING LIST
24V Cordless Line Trimmer
Safety Guard with Screws
Auxiliary Handle Assembly with Locking Knob
Flower Guard
(1) 24V, 2.5Ah Battery
Charger
Operator's Manual
WARNING!
Do not use this product
if any parts on the Packing List are already
assembled to your product when you unpack
it. Parts on this list are not assembled to the
product by the manufacturer and require
customer installation. Use of a product that
may have been improperly assembled could
result in serious personal injury.
■ Inspect the product carefully to make sure
no breakage or damage occurred during
shipping.
■ Do not discard the packing material until
you have carefully inspected and satisfactorily
operated the product.
■ If any parts are damaged or missing, do not
operate the product. Return it for replacement
to the retailer from which it was purchased.
ATTACHING THE SAFETY GUARD
See Figure 12, page iv
WARNING!
The line cut-off blade on
the safety guard is sharp. Avoid contact with
the blade. Failure to avoid contact can result
in serous personal injury.
■ Align the safety guard with the spool head.
■ Secure guard by tightening the mounting
screws with a screwdriver.
WARNING!
If any parts are damaged
or missing do not operate this product until
the parts are replaced. Use of this product
with damaged or missing parts could result in
serious personal injury.
ATTACHING THE AUXILIARY HANDLE
See Figures 2-7, page ii
■ Loosen the locking knob counterclockwise
and remove it from the auxiliary handle.
■ Align the auxiliary handle with the handle
support. (Fig. 2)
■ Insert the locking knob through the
auxiliary handle and partially tighten the knob
clockwise by hand. (Fig. 3)
■ Adjust the auxiliary handle to desired
position. (Figs. 4-6)
■ Tighten the locking knob clockwise and
clamp the lever down to secure it. (Fig. 7)
NOTE:
Only tighten the locking knob so that
it is possible to clamp the lever down with
light pressure. If the lever cannot be clamped,
slightly loosen the locking knob. If the lever
can be clamped without resistance, tighten
the locking knob.
ATTACHING THE FLOWER GUARD
See Figures 8-11, page iii
■ Align and seat the steel flower guard rails
into the 2 recessed channels on either side of
the motor housing.
■ Once aligned and with the steel rails of the
flower guard seated into housing channels,
slide the guard forward until the closed end of
the guard is against the motor housing.
■ With the two steel rails exposed, align the
two holes in the plastic toe pad with the end
of the steel rails of the guard and snap into
place securely.
WARNING!
Do not attempt to modify
this product or create accessories not
recommended for use with this product. Any
such alteration or modification is misuse and
could result in a hazardous condition leading
to possible serious personal injury.
WARNING!
To prevent accidental
starting that could cause serious personal
injury, always remove the battery pack from
the product when assembling parts.
Содержание 151.50227
Страница 27: ...vii Fig 26 Fig 28 Fig 29 Fig 30 Fig 27 30 ...
