6
Assembly (continued)
A Phillps head screw driver is required.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet.
(Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank and place on a fl at clean
surface. (Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on carton
content list on page 5. (Fig. 4)
5. With the power head removed, turn
the collection tank upside down.
Insert the four caster assemblies
into each socket. Apply pressure
until caster assemblies fully seated.
(Fig. 5) Secure them with the screws
provided. Do not over tighten the
screws.
WARNING:
Do not plug in power
cord to power outlet, make sure
plug is disconnected before
assembling the wet/dry vac.
!
1
4
5
2
3
10
8
9
7
6a
6b
6c
6d
6. Position the hose storage rack
as illustrated. Fully insert one end
of the hose storage rack into the
slot illustrated buy the arrow, then
pull the other end of the hose
storage rack to align with the
corresponding arrow and insert into
the slot until it is secured in place.
(Fig. 6a - Fig. 6d)
7. Place the power head back on the
collection tank, and secure into
place using the 2 side latches.
(Fig. 7 & Fig. 8)
8. Insert the locking end of the hose
into the port on the collection tank
and turn to lock in to place. (Fig. 9)
9. Choose the desired accessory and
insert onto the end of the hose
(Fig. 10)
10. After vac use, store hose,
accessories and cord as illustrated
on page 12.
