page 6
9. Blade Assembly.
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (
save blade arm screws and
lock washers to secure blade arms
). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Secure all screws.
Note
: Tighten blade arm screws twice a year.
J
motor
housing
blade
lock washers
blade arm
screws
blade attachment
screws and washers
blade arm
10. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain. Start at the OFF position (no blade movement).
First pull will set the fan to HI. Second pull will set the
fan to MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. If fan does
not function, please refer to "Troubleshooting" section
to solve any issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (
diagram 1
)
- UP position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely UP
or
completely DOWN
for fan to function. If
the reverse switch is set in the
middle
position
(
diagram 3
), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to end of the pull
chain.
diagram 1
diagram 2
diagram 3
plastic
motor
lock
reverse
switch
pull chain
extension
