page 9
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter
plate with loosened screws in motor plate,
allowing molex connections from motor
housing to come through hole in middle of
fitter plate. Twist fitter plate to lock. Re-insert
screw that was just removed and securely
tighten all 3 screws with a Phillips screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from LED light kit. Connect
BLACK
(or
BLUE
) wire from motor housing to
BLACK
wire from LED light kit. [
NOTE
: It may be
necessary to push back sleeve on wires to be
certain of wire colors.] Be sure molex
connections snap together securely.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
If you wish to USE the light kit
, align grooves
on shade with nodules on inside of LED light kit
and push up gently on shade. Turn shade to the
RIGHT (clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make
sure that shade is secure.
If you do NOT wish to use the light kit
,
align
grooves in metal cover with nodules on inside
of LED light kit. Push up on metal cover and
then turn metal cover to the
RIGHT (clockwise)
until it no longer turns.
WARNING
: Metal cover will be HOT if light is
left on.
fitter
plate
motor plate
molex
connections
LED light kit
motor
housing
fitter
plate
motor
housing
LED light kit
shade
metal cover
motor
housing
LED light kit
motor housing
fitter plate
molex
connections
groove
nodule
groove
nodule
