page 8
10. Testing Your Fan.
9. Switch Housing Assembly.
diagram 2
diagram 3
diagram 4
diagram 1
Remove 3 screws from outer edge of switch housing
plate (
save screws for later use
).
Remove 1 screw from fitter plate on underside of motor
and partially loosen the other 2 screws. Align slotted
holes in center of switch housing plate with loosened
screws in fitter plate, allowing male plug from motor
housing to come through hole in middle of switch
housing plate. Twist switch housing plate to lock.
Re-insert screw that was removed and secure all screws.
Connect male plug from motor housing to female plug
from switch housing. Make sure plugs connect tightly.
Align holes in switch housing with holes in switch
housing plate. Re-insert screws that were previously
removed and use a Phillips screwdriver to secure all
screws.
switch housing
plate
switch housing
male plug
female plug
fitter
plate
motor housing
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and wall switch (if applicable). Test fan speeds
with pull chain. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second
pull will set the fan to MEDIUM. Third pull will set
the fan to LOW. Fourth pull will re-set the fan to
OFF setting. (
diagram 1
) If fan does not function,
please refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch (located on switch housing). Set reverse
switch to recirculate air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for
fan to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to end of the
pull chain.
switch housing
pull chain
extension
reverse
switch
motor housing
