6. Wiring.
page 8
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning nodules
in canopy cover with notches in center hole on
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
hanging
bracket
canopy
screw
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is
present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket,
wire the RECEIVER
with wire
connectors provided
as shown in diagram at
right.
Tip
: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside
of hanging bracket.
ground (green
or bare)
white supply wire
black supply wire
from receiver
black AC IN L
AC IN N
white
white
ground (green or bare)
ground (green/yellow)
antenna
from ceiling
receiver
black
*
ground (green)
red
red
yellow
yellow
gray
gray
from
receiver
from fan
screw
canopy cover
