page 8
10. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain. Start at the OFF position (no blade movement).
First pull will set the fan to HI. Second pull will set the
fan to MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF setting.
(diagram 1) If fan does not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to end of the pull
chain.
fan
pull chain
extension
diagram 2
diagram 3
diagram 4
diagram 1
LED light kit
9. LED Light Kit Assembly.
Remove 3 screws switch housing cap at top of LED
light kit. Locate BLUE (or BLACK) and WHITE wires in
motor housing labeled FOR LIGHT KIT CONNECTION.
Remove and discard plastic that holds these 2 wires
together.
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire
from LED light kit to BLUE (or BLACK) wire from
motor housing. Be sure molex connections snap
together securely.
Carefully arrange wiring within switch housing
cap. Thread pull chains through corresponding
holes in LED light kit.
Align holes in switch housing cap with holes in
switch housing. [NOTE: The gap on the top edge
of the switch housing cap must align with reverse
switch on the switch housing for the proper fit.]
Re-insert screws that were previously removed
and securely tighten all 3 screws with a Phillips
screwdriver.
Locate slots on shade and align with nodules on
underside of LED light kit.
Gently push up on shade
and turn
to the RIGHT (clockwise)
until it slides
completely into place.
Pull down VERY GENTLY on shade to make sure that
shade is secure.
shade
switch
housing
cap
nodules
slots
switch housing
molex
connections
motor housing
reverse
switch
light
pull chain
extension
