page 9
10. Wall Control Operation.
slide switch for fan
L1 - turns fan to LOW speed
L2 - turns fan to MEDIUM-LOW speed
M - turns fan to MEDIUM speed
H - turns fan to HIGH speed
O - fan is OFF
slide switch for light
controls dimming capability for light
[Move slide switch up or down to
control light brightness.]
slide switch
for FAN
(right side)
slide switch
for LIGHT
(left side)
It is recommended that you test fan before
finalizing installation. Slide the knobs to “O”
(OFF) position on wall control. Restore power
from circuit box. Test fan speeds with slider
switch on right side of wall control. Start at the
OFF position (no blade movement) and try
each of the 4 different fan speeds, starting at
HIGH, then MEDIUM, MEDIUM-LOW and LOW.
Test light with slider switch on left side of wall
control; test brightness levels and OFF.
If fan and/or light do/does not function
properly, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch (located on top of the motor
housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely LEFT or completely RIGHT for fan to
function. If the reverse switch is set in the
middle position (diagram 3), fan will not
operate.
11. Testing Your Fan.
OFF
HIGH
MEDIUM
MEDIUM-LOW
LOW
FAN
SPEEDS:
LIGHT
DIMMER
motor
housing
reverse
switch
diagram 1
diagram 2
diagram 3
