page 7
9. Light Kit Assembly.
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws in
motor plate, allowing the male plug from
motor housing to come through hole in middle
of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a Phillips
screwdriver. (
diagram 1
)
Remove 1 screw from post located on
underside of fitter plate and partially loosen
the other 2 screws on the other 2 posts.
Connect male plug from motor housing to
female plug from the light kit fitter. Make sure
plugs connect tightly. Align slotted holes in
light kit fitter with loosened screws in fitter
plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed and
tighten all 3 screws securely. (
diagram 2
)
Remove 1 screw from light kit fitter and
partially loosen the other 2 screws. Connect
WHITE
wire from LED light kit to
WHITE
wire
from light kit fitter. Connect
BLACK
wire from
LED light kit to
BLACK
(or
BLUE
) wire from
light kit fitter. Be sure that molex connections
snap together completely. Align slotted holes
in outer edge of LED light kit with loosened
screws in light kit fitter. Twist LED light kit to
lock. Re-insert screw that was removed and
secure all screws. (
diagram 3
)
Locate slots on glass shade and align with
nodules on light kit fitter. Slide glass shade
onto light kit fitter and gently turn glass shade
in a clockwise direction until it slides into place.
(
diagram 3
)
NOTE
: Pull down
VERY GENTLY
on glass shade
to make sure that glass shade is secure.
light kit fitter
motor housing
diagram 2
diagram 1
motor housing
motor plate
fitter
plate
fitter plate
male plug
female plug
diagram 3
glass shade
nodules
motor housing
light kit fitter
molex plugs
LED light kit
slots
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected..
Consult the dealer or an experienced radio/TV technician for help.
