page 8
11. Automated Learning Process./Activating Code.
TRANSMITTER
(front)
CAUTION
:
The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
This remote control transmitter is equipped with
16 code combinations to prevent possible
interference from or to other remote units such as
garage door openers, car alarms or security
systems. If you find that your fan and light go on
and off without using your remote control, simply
change the combination code in your remote
control transmitter.
To set the code, perform
these steps:
Remove battery cover on back side of transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Note
: Since this fan comes with incandescent
bulbs, the dimmer switch (labeled
D
and
X
) has
been pre-set to the "ON" position (
D
). If you do not
wish to have dimming capability, please move the
switch to the "OFF" position (
X
).
Install 9-volt battery (included) in transmitter and
then replace the battery cover.
IMPORTANT
: To prevent damage to transmitter,
remove the battery if not used for long periods.
Restore electrical power. Within 30 seconds of
restoring the power, press and hold the "OFF"
button, located on the front of the transmitter, for
5 seconds or until light on fan blinks twice. Test
the light and fan functions to confirm the learning
process is complete--see Section 13.
dimmer
switch
dip
switches
1
TRANSMITTER
(back)
battery
battery
cover
