11. Remote Control Operation.
page 6
7. Canopy Assembly.
canopy
hanging bracket
screw
6. Wiring. (cont.)
antenna
receiver
IN ORDER TO WIRE WALL CONTROL
, remove existing wall switch. Wire
the
WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with electrical tape as an extra
safety measure. Gently push taped wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the code switches
1 through 4 on the wall control. Factory setting is pre-set and not
recommended for use.
Write down number sequence for use in Section 9.
[
Note
: Since this fan comes without a light kit, set the dimmer switch
(labeled "D" and "X") in the "OFF" position (X).]
Attach wall control to outlet box and secure with screws from original
wall switch. Attach front plate to wall control using 2 screws provided
in the wall control.
8. Blade Assembly.
motor
housing
fan
motor
blade
blade arm
plastic
motor
lock
lock washer
blade arm screw
blade attachment
screws and washers
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
(wiring for wall control)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
control
plate
1
2
3
4
X
D
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of of the
hanging bracket. Partially loosen the other screw. Lift
canopy to hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed, and then tighten
both screws securely.
*Remember that antenna for remote control receiver
must rest
outside
of hanging bracket.
code
switches
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 20 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade and
align holes. Insert 4 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
).
Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat
procedure with remaining blade arms. Securely
tighten all screws.
Note
: Tighten blade arm screws twice a year.
