page 7
6. Wiring.
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to
the OFF position.
CAUTION
:
Be sure outlet box is properly grounded or
that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When fan is secured in place on the hanging bracket,
electrical wiring can be made as follows:
Connect
BLACK
wire from fan to
BLACK
wire from
ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from
fan to
BARE
/
GREEN
wire from ceiling with wire
connector provided.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
wire
connector
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
from ceiling
from fan
ground
(green or bare)
*
[
PLEASE NOTE
: Wall and/or handheld remote control
must be used for fan to operate.
If you do
not
wish to
use the wall control, please proceed to Section 7, page 8
to continue with fan installation.
]
To install wall control
, remove existing wall switch.
Wire one of the
wall controls with wire connectors
provided
as shown in diagram at right.
*Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires
and taped wire connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT
: Wall control will not function unless
battery is installed.
Since this fan comes with a LED light kit, the dimmer
switch (labeled
ON
and
D
) has been pre-set to the
the "
ON
" position. If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (
D
).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided
with the wall control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
12V battery
dimmer
switch
plate
I
II
IV
VI
III
V
V
WARNING
:
Choking Hazard
- Small parts.
Keep battery away from children.
