page 7
PLEASE NOTE: Wall and/or remote conrol must be used
for fan to operate. If you do not wish to use the wall
control, please proceed to Section 8 to continue with fan
installation.
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch. Wire the WALL CONTROL with wire
connectors provided as shown in diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
WARNING: CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect GREEN ground wire to ground from house or
directly to one of the screws from the outlet box.
Connect one BLACK wire from wall control to BLACK
(hot) lead wire from house. Connect second BLACK wire
from wall control to BLACK load wire to fan.
Attach wall control to outlet box and secure with screws
from original wall switch. Attach front plate to wall
control using 2 screws provided in the wall control.
8. Canopy Assembly.
Lift canopy to hanging bracket. Place rounded
part of holes in canopy over screws in hanging
bracket and push up. Twist canopy to lock.
Tighten both screws securely.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
outlet box
wall
control
(wiring for wall control)
plate
1
2
3 4
5
6
green/
bare
ground
black
7. Wiring. (cont.)
hanging bracket
screw
antenna
motor housing
canopy
screw
hole
