page 6
7. Canopy Assembly.
canopy
hanging bracket
8. Blade Assembly.
motor housing
blade screw and washer
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade (
sold separately
) and align holes. Insert
3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with Phillips screwdriver.
Repeat procedure for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (
save blade arm screws and
lock washers to secure blade arms
).
Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat procedure with remaining blade arms.
Securely tighten all screws.
Note
: Tighten blade arm screws twice a year.
plastic
motor
lock
blade arm
blade
blade attachment
screws and washers
lock washers
blade arm
screws
screw
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.
