page 7
8. Blade Assembly.
Time Saver:
Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 9 blade attachment screws and washers and
9 decorative nuts in one of the hardware packs. Place
blade arm on
TOPSIDE
of blade, aligning holes in blade
arm with holes in blade as shown. Insert 3 decoratvie
nuts into holes in blade from
UNDERSIDE
of blade (
i.e.,
the side that will face the floor
), making sure to
completely insert
each decorative nut so that the
blade arm can be attached correctly. Insert 3 blade
attachment screws (along with washers) from
TOPSIDE
of blade with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat procedure
for remaining blades.
Remove blade arm screws and lock washers from fan
motor and set aside. [
WARNING
: Do NOT remove the
4 screws located on the outer rim of the underside of
the motor housing--doing so or any attempt at doing
so will void the warranty.] Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing screws
permanently, repeat this procedure with remaining
blade arms. Secure all screws.
NOTE
: Tighten blade arm screws twice a year.
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2 screws.
Align slotted holes in center of fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through hole
in middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed and
securely tighten all 3 screws with a Phillips screwdriver.
Remove 1 screw from post located on underside of
fitter plate and partially loosen the other 3 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire
from motor housing to
BLACK
wire from light kit fitter.
Be sure molex connections snap together securely.
Align slotted holes in light kit fitter with loosened
screws in fitter plate. Twist light kit fitter to lock.
Re-insert screw that was previously removed and
tighten all 4 screws securely.
Install 2 candelabra base 60 watt max. bulbs (included).
Important
: When replacing bulbs, please allow bulb(s)
and glass shade to cool down before touching them.
Align grooves on glass shade with nodules on inside of
light kit fitter and push up gently on glass shade. Twist
glass shade to the RIGHT (clockwise) until glass shade
locks into place.
Pull down VERY GENTLY on glass shade to make sure that
glass shade is secure.
motor housing
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws and washers
blade arm screws
and lock washers
TRANSMITTER
(front)
light kit fitter
molex
connections
glass shade
bulb
motor housing
fitter plate
molex connections
motor plate
