Craftex CX800, Руководство пользователя

Страница: 11 / 26

11
TO REMOVE THE FACEPLATE:
Make sure the spindle lock pin is engaged.
Loosen the four screws securing the
faceplate to the spindle and unthread the
faceplate.
CONTROL PANEL
The control panel for CX800 is located in
front of the machine just below the
headstock.
Refer to figure-9 reading the descriptions
below and familiarize yourself with the
controls on your CX800.
Figure-9 CX800 Control panel
A. ON BUTTON: Starts the spindle
rotation.
B. OFF/EMERGENCY STOP BUTTON:
Stops the spindle rotation.
C. FORWARD/REVERSE SWITCH:
Changes the direction of rotation of the
spindle to clockwise or anticlockwise.
D. SPINDLE SPEED CONTROL KNOB:
Adjusts the spindle speed from low to
high within the range the belt is
positioned on the pulleys.
E. SPINDLE RPM DIGITAL READOUT:
Shows the spindle RPM (rotation per
minute) in digital form.
WARNING
The faceplate must be properly threaded
onto the spindle and secured by
tightening the four set screws to prevent
the work-piece from flying off during
operation. Failure to follow these
instructions could cause serious
personal injuries.
WARNING
Make sure the switch is in the OFF
position and the cord is disconnected
from the power source before installing,
servicing and removing/replacing any
components on the machine. Failure to
do so may result serious personal
injuries.