Craftex CX502, Руководство пользователя

Страница: 10 / 17

10
MAINTENANCE
During the life of your tool, you will need to
practice some regular maintenance to keep
your sander in peak performance condition.
Before using the machine, make sure to
inspect the sander for the following:
Loose bolts, screws and nuts
Sanding drum and sleeve is installed
properly
Worn or damaged cord
Damaged sanding sleeve
Or any other unsafe condition
Make sure to turn the machine OFF after
use and clean all the sawdust from the work
table and the surrounding areas. Clean the
work table using a piece of cloth and make
sure there is no moisture on it to prevent
from rusting.
SQUARING TABLE TO THE
SPINDLE
The table is squared with the spindle at the
factory, however after a long period of time
the table might come out of alignment with
the spindle.
To check if the spindle is square to the
table:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Place a square on the work table as shown
in figure-7.
If the square is touching the spindle drum
with its full length and it is sitting on the
table properly, then the table is square to
the spindle.
If the square is not touching the spindle
drum with its full length, it means the
spindle and table are not square to each
other and need to be adjusted.
Open the table tilt locks and adjust the table
so that the square placed on the table is
sitting on the table and touching the spindle
drum with its full length.
Once the table is square with the spindle,
loosen the screw on the angle indicator on
the tilt scale and make it “0”. Re-tighten the
screw and secure the indicator in position.
WARNING
When installing / removing and servicing
any part of the machine, make sure the
power switch is in the OFF position and
the cord is disconnected from the power
source. Failure to do so may result in
serious personal injury.