Craftex CT170N, Руководство пользователя

Страница: 12 / 17

12
Figure-10 Squaring table to the belt
Figure-11 Squaring table to the disc
SANDING BELT
REPLACEMENT
To replace the sanding belt:
Make sure the switch is in the OFF position
and the cord is disconnected from the
power source.
Remove the upper guard and the side
cover by removing the lock knob and
loosening the two screws securing the
upper guard and the side cover. See figure-
12.
Figure-12 Removing the side cover
The middle roller features spring at the
back and can be pushed towards the table.
To remove the belt, hold the adjusting shaft
guard and apply moderate pressure just to
loosen the belt tension and push it towards
the table. See figure-14.
Figure-13 Replacing the belt
Take the belt off the rollers with the other
hand and replace it with a new one.