Craftex CT148, Инструкция пользователя

Страница: 12 / 19

12
ASSEMBLY
Adjusting the Mitre Gauge (Fig. 7)
The miter gauge is used with the worktable to sand work piece with miter angles
or compound angles when the worktable at a tilt angle. The angle between the
body and the bar can be set from 90°
to 45° left or right
Check the squareness with a combination square and adjust the pointer if
necessary. Remember the miter gauge is a convenient guide but not be relied
upon for ultimate precision.
OPERATION
Never connect the plug to the power source outlet until all installations and
adjustments are completed and you have read and understood the safety and
operational instructions. The belt and disc sander is designed to perform rough
sanding operations on surface, edge grain and end grain sanding. The sander
will also perform freehand forming and contouring operations.
1
Always apply light pressure allowing the abrasive to remove the material
slowly.
2
The work piece should be moved, continuously, to avoid burning.
3 Avoid sanding small pieces of wood which will position the fingers close to
the abrasive belt or disc.
4
Use the miter gauge and worktable to perform miter or compound angle
sanding.