10
11
¨
RE
AD
Y
OPERATION
WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
n
Drilling in wood
n
Drilling in ceramics, plastics, fiberglass, and laminates
n
Drilling in metals
n
Mixing paint
CAUTION:
If at any point during the charging
process none of the LEDs are lit, remove the bat-
tery pack from the charger to avoid damaging the
product. DO NOT insert another battery. Return the
charger and battery to your nearest service center
for service or replacement.
LED FUNCTIONS OF CHARGER
LED WILL BE ON TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
n
Red LED on = Fast charging mode.
n
Red LED flashing = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of normal temperature range.
n
Green LED on = Fully charged and in maintenance
charge mode.
n
Yellow LED on and red LED flashing = Deeply
discharged or defective battery pack.
n
No LED on = Defective charger or battery pack.
CHARGING A COOL BATTERY PACK
If battery pack is below normal temperature range, the
red LED on charger will flash. Allow battery pack to reach
normal temperature, then the red LED will become steady.
NOTE:
If the charger does not charge the battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Sears Repair Center for
electrical check.
n
Charge the battery pack only with the charger provided.
n
Make sure the power supply is normal household
voltage,
120 V, 60 Hz, AC only
.
n
Connect the charger to the power supply.
n
Attach battery pack to charger by aligning raised rib on
battery pack with grooves in charger, then slide battery
pack onto charger.
See Figure 2.
n
Normally the red LED on charger will come on. This
indicates the charger is in fast charging mode.
n
Red LED should remain on for approximately 1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is
in maintenance charge mode.
NOTE:
The green LED will remain on until the battery
pack is removed from the charger or charger is
disconnected from the power supply.
n
If the yellow LED comes on and the red LED flashes,
this indicates a deeply discharged or defective battery
pack. Allow the battery pack to remain in the charger
for 60 minutes. When the battery pack reaches normal
voltage range, the red LED should become steady. If
the red LED does not come on after 60 minutes, this
may indicate a defective battery pack and should be
replaced.
n
After normal usage, a minimum of 1 hour of charging
time is required to fully recharge battery pack.
n
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
n
Do not place the charger and battery pack in an area
of extreme heat or cold. They will work best at normal
room temperature.
n
NOTE:
The charger and battery pack should be placed
in a location where the temperature is more than 50°F
but less than 100°F.
� When batteries become fully charged, unplug the char-
ger from power supply and remove the battery pack.
Fig. 2
FULLY CHARGED
(GREEN LED)
FAST CHARGE
(RED LED)
BATTERY
DEEPLY DISCHARGED
OR DEFECTIVE
(YELLOW /
RED LED)
TO REMOVE
TO ATTACH
