14
Wet Nozzle
To pick up liquids off a smooth surface,
use the 2-1/2 inch wet nozzle accessory
supplied with your wet/dry vac. To use
this nozzle, simply attach the nozzle to
the end of an extension wand.
Connect a second extension wand to the
first, and connect the 2-1/2 inch x 7 foot
hose to the extension wand.
Liquids may be picked up by dragging the
nozzle across the surface. The squeegee
will dry the surface as you vacuum.
Replacement rubber for the squeegee
nozzle may be obtained through Sears
Parts. If the rubber becomes worn, it may
be flipped over for use on the opposite
side or replaced. (Replacement service
part #822256). To reverse or replace the
squeegee:
1. Lay the wet nozzle on a flat surface
with the round inlet opening facing up
and the two latches close to you as
shown.
2. Using both hands, position each
thumb on the removable insert, (below
the latches) and two fingers of each
hand on each latch, lift and disengage
the two latches from the tabs on the
nozzle body.
3. Gently pull the latches toward yourself
to remove the insert.
To reinstall the removable insert cor-
rectly, follow these steps:
1. Place the removable insert on a flat
surface with the pins positioned
upward and the latches close to you
as shown. Place the rubber squeegee
on the insert, with the pins fitting
through the matching holes in the
Nozzle
Body
Latches
Removable
Insert
squeegee. (Make sure the new work-
ing edge is located farthest from you.)
2. Using both hands, lower the nozzle
body onto the insert and squeegee
with the round opening of the nozzle
closest to you. With fingers on the far
side and thumbs holding the latches of
the removable insert, flip the nozzle
over so the latches are on the top and
the round inlet opening is facing away
from you. Make sure the squeegee
stays on the insert pins.
3. Press down with each thumb below
the latching tabs until you see and
hear the removable insert snap into
the nozzle body. Snap the latches over
the locking tabs into their original posi-
tion.
4. Inspect the pins of the insert to make
sure they fit through the holes of the
squeegee and fit into the matching
slots in the nozzle body.
NOTE: If the pins are out of position, hold
the nozzle assembly with both hands and
gently twist in opposite directions. The
insert pins should snap into proper posi-
tion.
Twist
Forward
Twist
Backward
The wet nozzle assembly is ready for wet
pickup use.
Maintenance continued)
SP6570 16 gallon detach 12/8/04 8:47 AM Page 14
